20000psi Oil Well Manifold Drilling Mud Manifold For Drilling Equipment

2 9/16" 20000psi Choke And Kill Manifold Drilling Equipment

The choke And Kill Manifold is used during well testing, The positive choke has a fixed diameter and the size of the orifice on the adjustable choke can be varied. In addition, the adjustable choke allows fixed chokes to be switched out as needed without stopping the well, increasing the flexibility of the overall system.

Choke And Kill Manifold Parameter

Choke And Kill Manifold Working Principles

When the pressure inside the well rises, opening/closing the choke valves(including manual chokes, hydraulic chokes, and positive chokes)on the choke manifold can allow the release of the fluid inside the well to control casing pressure, which can be directly blown out through the gate valve if the casing pressure is quite high.
4. Pressure Ratings
The Choke And Kill Manifold is available in pressure ratings of 2000psi,3000psi,5000psi,10000psi, and 15000psi, and also can be available upon customer request.

Operating Instructions

(1) The working pressure of all components on the choke manifold shall be compatible with that of the BOP stack used.
(2) The choke manifold shall be installed at a place where the operator can reach it easily. The pressure test must be performed before installation and the seat test pressure shall be equal to the rated working pressure.
(3) The line pipe shall be level and straight as much as it could. In case of the turn of the line pipe, the 120-degree steel bent pipe shall be used. The bore of the line pipe shall be large enough.
(4) The pressure gauge must be installed.
(5) In winter, the choke manifold can work under a low-temperature conditions.