0.02mm Resolution Bench Automated Dispensing Machines LCD Panel Control

Machine Specifications:

Advantages

1. English LCD panel teach pendant, easy operation and learning.
2. Three axis movement robot has the function of drawing points, lines, surfaces, arc, circle, irrecular curves consecutive interpolation.
3. Dispensing volume, dispensing speed, dispensing time, stopping dispensing time can be set.
4. Autmatic curving protection.
5. Special dispensing controller makes fluid flow stable without leaking and dripping.

Our Services

1. Stable quality, competitive price, one year free parts warranty except for dispensing consumables, such as plastic pipes, needles. Over the warranty, lifelong maintenance is also available with some charges.

2. One week delivery after down payment for standard type.

Installation:

The automatic dispenser machine can satisfy various requirements for dispensing, only need to choose different fixtures and math with dispensing systems.

The following installation instruction is based on the 30CC needle cylinder clamp and simple type dispensing system as a model.
1. The standard accessories include the 30CC needle cylinder clamps, and they can be applied to 30CC or 55CC needle cylinder. If you want to use other needle cylinder, then you have to purchase other needle cylinder clamps appropriate.

2. Fix the needle cylinder clamps onto the Z axle. Put the hexagon socket flat head screws through the holes of the clamps and then lock on the Z ground side. The clamp has a couple of holes to select, according to the specific requirements .

3. Connect the signal port(three holes) of the dispenser machine on the backside to the signal port in the controller with dispenser signal line. The signal port in the dispenser machine is the same one that connecting with the foot-plate. Thus a problem may appear that the port can not be shared, if your dispenser machine is not purchased along with the matching machine. In such case, please contact the Extruder supplier for joint exchanging.

4. Connect the compressed air source to the dispenser controller, put the needle cylinder collet onto the needle cylinder and tighten it, and put the needle cylinder into the needle cylinder clamps and lock the screws which are used to fix the needle cylinder.( Please don’t over tighten, in case of deformation. And once it deforms, the piston then cannot fit with the inner side of the needle cylinder, and cause air leakage.)

5. Connect the handheld programmer to the machine.

6. Connect the dispenser machine and the controller to 220V power source.

7. Do make sure the pressure pipe of the needle cylinder collet and the power source will not influence the motion of each axles and working plate.

8. Congratulations for completing primary set of the dispenser machine, please learn teaching mode operation according to the following chapters.