Product Details
Company Profile

3.5 Inch Mipi Interface TFT Display module 320x480 industrial touch display

3.5 inch Mipi interface industrial touch display 320x480 touch TFT display introduction

Feature

touch TFT display: 480 x 320 display resolution (HDMI input resolution supports 480*320 to 1920*1280 any resolution); 3.5mm audio/headphone jack makes the display no longer silent.
Perfect for Raspberry Pi 4: Micro HDMI adapter included, hassle-free connection to Raspberry Pi 4; Also compatible with all other Model A&B series.
Efficient heat dissipation: This screen is mounted with a brushless quiet fan and powerful heat dissipation, you don't need to worry about the overheating problems and the noise.
More Features: supports HDMI audio split; Refreshes up to 30 frames per second; The backlight can be turned on/off. Plug & Play: Don’t need to reboot the Pi when connected and it doesn’t require any external power supply.
Portable Touchscreen: the overall dimension of this tiny screen is 3.38”×2.20” (86mm×56mm), and the included stylus, heatsinks, and HDMI adapters make this kit completed and convenient to use.

The specification YT035F001 is a 3.47” a-Si TFT Liquid Crystal Display ODF cell. The ODF cell has been designed by INX, and manufactured by INX under the agreement of customer. The a-Si TFT-LCD cell will be applied to a high transmittance operating in the normally black modea-Si TFT-LCD product.

Product Specification of 3.5 inch industrial touch

General Features
Diagonal Size	3.5 inch	Type	LCM, a-Si TFT-LCD
Pixel Format	1440(RGB)×1600	Configuration	RGB Vertical Stripe
Active Area	59.4 (W)x66.0 (H) mm	Outline Dim.	62.2 (W)x73.6 (H)x1.65 (t) mm
Bezel Area	-	Treatment	Hard coating
Luminance	150 cd/cm2 (Typ.)	Contrast Ratio	700:1 (Typ.)
View Direction	Symmetry	Response Time	5 ms (Tr+Tf) (Min.)
Viewing Angle	60/60/60	Operating Mode	IPS, Normally Black, Transmissiv
Support Color	16.7M	Light Source	Light Emitting Diode (LED), 10 LEDs (2in1) ; 5 series 2 strings
Weight	17.0g (Typ.)	Designed For	HDM VR AR
Frame Rate	90Hz	Touch Panel	Optional
Interface Type	MIPI-DSI Video mode with data compression (4-Lane x 1-Port)
Power Supply	1.8/5.7/-5.7V (Typ.)(VDDI/AVDD/AVEE)
Environment	Storage Temp.: -20 ~ 70 °C Operating Temp.: -10 ~ 55 °C

Outline Dimension (unit: mm)

Application scenarios

General Precautions

P.1 Use Restriction

This product is not authorized for use in life supporting systems, aircraft navigation control systems, military systems and any other application where performance failure could be life-threatening or otherwise catastrophic.

P.2 Handling Precaution

(1) Please mount LCD module by using mounting holes arranged in four corners tightly.

(2) Do not disassemble or modify the module. It may damage sensitive parts inside LCD module, and may cause scratches or dust on the display. IVO does not warrant the module, if customers disassemble or modify the module.

(3) If LCD panel is broken and liquid crystal spills out, do not ingest or inhale liquid Crystal, and do not contact liquid crystal with skin. If liquid crystal contacts mouth or eyes, rinse out with water immediately. If liquid crystal contacts skin or cloths, wash it off immediately with alcohol and Rinse thoroughly with water.

(4) Disconnect power supply before handling LCD module

(5) Refrain from strong mechanical shock and /or any force to the module.

(6) Do not exceed the absolute maximum rating values, such as the supply voltage variation, input voltage variation, variation in parts’ parameters, environmental temperature; etc otherwise LCD module may be damaged. It’s recommended employing protection circuit for power supply.

(7) Do not touch, push or rub the polarizer with anything harder than HB pencil lead. Use fingerstalls of soft gloves in order to keep clean display quality, when Persons handle the LCD module for incoming inspection or assembly.

(8) When the surface is dusty, please wipe gently with absorbent cotton or other soft Material. When cleaning the adhesives, please use absorbent cotton wetted with a little Petroleum benzene or other adequate solvent.

(9) Wipe off saliva or water drops as soon as possible. If saliva or water drops Contact with polarizer for a long time, they may causes deformation or color Fading.

(10) Protection film must remove very slowly from the surface of LCD module to Prevent from electrostatic occurrence.

(11) Because LCD module uses CMOS-IC on circuit board and TFT-LCD panel, it is Very weak to electrostatic discharge, Please be careful with electrostatic Discharge .Persons who handle the module should be grounded through adequate methods.

(12) Do not adjust the variable resistor located on the module.

P.3 Storage Precaution

(1) Please do not leave LCD module in the environment of high humidity and high temperature for a long time.

(2) The module shall not be exposed under strong light such as direct sunlight.Otherwise, Display characteristics may be changed.

(3) The module should be stored in a dark place. It is prohibited to apply sunlight or fluorescent light in storage.

P.4 Operation Precaution

(1) Do not connect or disconnect the module in the "Power On” condition.

(2) Power supply should always be turned on/off by "Power On/Off Sequence"

(3) Module has high frequency circuits. Sufficient suppression to the electromagnetic interference should be done by system manufacturers. Grounding and shielding methods may be important to minimize the interference.

(4) After installation of the TFT Module into an enclosure, do not twist nor bend the TFT Module even momentary. At designing the enclosure, it should be taken into consideration that no bending/twisting forces are applied to the TFT Module from outside. Otherwise the TFT Module may be damaged.

P.5 Others

(1) Ultra-violet ray filter is necessary for outdoor operation.

(2) Avoid condensation of water which may result in improper operation or disconnection of electrode.

(3) If the module keeps displaying the same pattern for a long period of time, the image may be "sticked" to the screen.

(4) This module has its circuitry PCB's on the rear side and should be handled carefully in order not to be stressed.

P.6 Disposal

When disposing LCD module, obey the local environmental regulations.

Product Tags:


*From:	Your email address is incorrect!
*To:	ShenZhen Adia Techology CO.,LTD
*Subject:	Subject is empty!
*Message:	For the best results, we recommend including the following details: -Self introduction -Required specifications -Inquire about price/MOQ Characters Remaining: (0/3000) Please enter 20 to 3000 characters to contact this supplier!

Categories	TFT LCD Displays
Brand Name:	Adia
Model Number:	YT035F001
Certification:	RoHS
Place of Origin:	china
MOQ:	10pcs
Price:	USD 4.8-5.8/ PCS
Supply Ability:	1k/m
Delivery Time:	20-25
Packaging Details:	50cm50cm60cm
Product name:	3.5 inch industrial touch display
Screen Size:	3.5 inch
Display Type:	3.5'' TFT/TRANSMISSIVE
Viewing Angle:	ALL
Driver IC:	ST7796S
Interface:	MIPI
Operating Voltage:	VDD=2.8V IOVCC=1.8V
Backlight:	WHITE(9.6V, 40mA/LED)