Galvanized Self Adhesive Insulation Pins Use for Air Conditioner

Quick details of Galvanized Self Adhesive Insulation Pins

Name:self adhesive insulation pins,self stick pins,self stick insulation pins

Self Adhesive Insulation Pins​ CAUTION:

The user is responsible for determining the suitability of the application. Hangers must be applied

to a clean, dry, non-porous surface that is free of all oil, films, dust, rust, etc. Self-adhering hangers

are not recommended for concrete or painted surfaces. It is important that they not be used where

operating temperatures can exceed 150° F at the point of adhesion. Hangers should not be used on

ceilings or roofs of metal buildings or any surface

the reverse side of which may be exposed to heat concentration from sunlight, etc., direct or otherwise.

Load per anchor should not exceed 3 lbs.

Self Adhesive Insulation Pins​ APPLICATION:

Best results are obtained when ambient temperature is above 40° F at the time of application. Remove

the release paper from the base plate and apply hanger to a suitable flat surface. A firm straight, forward

pressure should be used. Do not twist. Due to the quick-tack nature of the adhesive, it is very important

that the release paper not be

removed until ready to apply the hanger. Insulation may be applied immediately after properly securing

the hanger. Hangers should be stored at 75° F and 50% relative humidity. It is important that stock be

rotated. Shelf life is estimated at 2 years if stored as recommended.




WIPE SURFACE CLEAN.Anchor should be applied to a clean, dry non-porous surface
PEEL OFF RELEASE BACKING.NOTE: Double faced foam tape has a one-year active shelf life
STICK ANCHOR IN PLACE.Select location before contact with surface.Press firmly

APPLY FIRM PRESSURE.20 pounds of pressure should be applied all around the base of the anchor
ALLOW TO STAND 15-20 MINUTES.This will permit better adhesion to take place


Package of Self Adhesive Insulation Pins​ :

15 YEARS EXPERIENCE
PROFESSIONAL MANUFACTURER OEM/ODM
ONE-STOP CUSTOM FACTORY
MEET YOUR INDIVIDUAL PROCESSING
ENSURE QUALITY AND PRECISION

About HUIHAO

China HUIHAO was established in 2013. We mainly manufacture and supply Wire mesh and insulation fastener. Our corporate headquarter is located in Changan Industrial area Shijiazhuang Hebei, factory is located in Anping Town Hengshui City. Both sites are adjacent to highway intersections, convenient and near to Tianjin ports.

We have been focused on manufacturing, research and development of wire mesh and insulation fastener more than 10 years, HUIHAO is a leading Chinese insulation fastener manufacturer knowing the European and American standards well, supply a full ranges of wire mesh, insulation pins and washers. They are widely used in HVAC, petrochemical industry, equipments insulation, shipyards, wall insulation etc. And moreover, we develop the solar panel mesh clips. In 2020 we expand our business lines of laser cutting and various customized stamping parts, providing one - stop OEM services.

Our main products are Round & Rectangular Lacing Anchor, Self Locking Washer, various of Cup Head Pin (SS Quilting Pin, Cup Head Weld Pin Insulated, Cup Head Weld Pin Without Insulation), Duct Liner Weld Pin, Perforated Base Pin, Self Adhesive Pin, Wire Mesh, various of Solar Panel Mesh Clip (stainless steel, aluminum and nylon)etc. All of our products are produced by own automatic production.

READ MORE

PACKAGING AND TRANSPORTATION

Standard packaging to ensure products arriving at destination in good condition