Choose your worktop thickness
Please enter your worktop sizesMeasure the length (mm) and width (mm) of each worktop piece,
breakfast bar and island unit and input them individually into the
Please note All lengths over 3 metres will be jointed.The positions
of the joints will be agreed with the client at the time of
All Worktops come with a complimentary chopping board in the same
granite as your worktops
The edges of the worktops that are visible require polishing, a
number of different profiles can be applied to these edges, ranging
from Single Pencil Arris to Full Bullnose
[-- Please select --]
Edging Total Length to be Polished in mm
Double Pencil Round, the most popular and economic edging, can also be made as a single
(upper edge only) profile.
Chamfered Edging, another popular profile which again can be supplied as single or
Half Bullnose, a stylish and contemporary profile
Full Bullnose, top of the range, sleek round profile
Ogee Edging, a traditional favourite
Please enter your upstand sizesUpstands are used behind the worktops, made from the same stone as
the worktops but usually in 20mm thickness. Upstands are usually
100mm high, but other heights can be specified.
Splashbacks are stone panels used behind hobs, ranges and sinks.
Splashbacks can also be fitted from the top of the worktops to
underside of the wall units.
Upstand Polishing (mm)
Radius & Additional Cuts
On Peninsular or Island Units you can choose to have curved,
(radiused), ends. You can also choose to have the corners of your
worktops rounded instead of squared off.
Radius & Additional Cuts - Radius Cuts
Radius & Additional Cuts - Rounded Corners
These are visible cut outs for under mounted, butler sinks etc that
require the inner exposed edges to be polished.
Enter Number of Polished Cutouts
These are the cutouts for taps and switch holes.
Enter Number of Tap Holes
These are straight grooves channelled into the worktop at the side
of the sink which act as a draining board. These are normally
supplied as a set of five grooves.
Enter Number of Sets of Groves (1 Set = 5 Grooves)
These are the cutouts with unfinished inner edges that are not
visible for surface (over) mounted sinks, hobs etc.
Enter Number of Unpolished Cutouts
These are the recessed cutouts for hobs etc.
Enter Number of Flush Hobs
* Mandatory Fields
A comprehensive care kit containing all you need to care for and
maintain your worktops in beautiful condition.
Enter Number of Care Kits
First Name *
Last Name *
Email Address *